GrowSpan Gothic Pro 106314R, Инструкция по эксплуатации

Страница: 30 / 57

GROWSPAN
™
GOTHIC PRO GREENHOUSES AND SYSTEMS
30
Revision date: 05.29.19
20. Take a 116051 (4' x 12') panel and cut it to the
dimension determined in previous step. This panel is
used to create two upper panels for the same bay.
ATTENTION:
If half of panel will work, use half. Panel
can overlap mid panel a few inches more than what is
shown in diagrams.
REMEMBER:
Use remainder of
this panel for top panel on opposite side.
21. Take a section of 12' H-channel (111929) and
cut a
piece that is 1" shorter than the panel length.
Repeat
step to cut another section for the other panel edge.
POLYCARBONATE ROOF PANELS (continued)
22. With assistant stationed inside and outside the frame,
carefully set panel on frame and overlap top of lower,
mid panel by 6".
23. Align panel and center H-channel with center of end
rafter and first interior rafter.
24. Secure panel to rafters as previously described using
FA4484B Tek screws and 102921 washers.
ATTENTION: Install upper Tek screws a few inches
down from peak to prevent interfering with the
installation of ridge cap. (See diagrams on next page.)
Use a section of ridge cap to gauge placement of Tek
screws that secure panel.
25. Repeat steps to prepare and install the adjacent upper
panel (same frame bay).
1"
Top edge
of panel
NOTE: This allows space for installation of the 104213
U-channel once panel is installed.
This distance
plus 6".
42"
Installed lower
roof panel.
Installed mid
roof panel.
Upper End of
Lower Panel
6"
Overlap
Line
19. Next, measure from peak to top of mid panel
and add
6" to allow for a 6" overlap
of each lower panel.