Groen TDH-20, Руководство оператора и по обслуживанию

Страница: 13 / 32

OM/SM-TDH-CE
12
3.9 Remove Gas Control Valve
(Turn
gas and electric mains off)
a) Remove control cabinet lid (Paragraph 3.5.1).
b) Remove control cabinet side panel (Paragraph
3.5.2).
c) Tilt kettle until the burners are fully exposed and
disconnect the pilot assembly from the burner
guard.
d) Remove the nuts securing the burner guard to
the appliance base and remove the burner
guard.
e) Undo the union fittings on either side of the
control valve and disconnect the electrical leads
from the control valve.
f) Remove control valve from control cabinet.
g) Replace in reverse order.
3.10 ON/OFF Switch and Reset Button
(Turn gas and electric mains off)
a) Remove control cabinet lid (Paragraph 3.5.1).
b) Remove cabinet side panel (Paragraph 3.5.2).
c) Disconnect electrical leads from the On/Off
switch or reset button.
d) Undo and remove retaining collar securing the
On/Off switch to the control cabinet outer
surface, and securing the reset button to the
inner surface of the control cabinet.
e) Withdraw the On/Off switch or reset button as
required.
f) Replace in reverse order.
3.11 Remove Neons
(Turn gas and electric
mains off)
a) Remove control cabinet lid (Paragraph 3.5.1).
b) Remove cabinet side panel (Paragraph 3.5.2).
c) Disconnect the electrical leads to the neon.
d) Undo and remove the retaining collar which
secures the neon to the control cabinet.
e) Withdraw the neon from the control cabinet.
f) Replace in reverse order.
3.12 Remove Thermostat
(Turn gas and
electric mains off)
a) Remove panel from kettle base by undoing the
retaining screws.
b) Drain kettle by tilting it slightly and undoing Phial
Boss connection. Allow kettle to drain into a
suitably sized container.
WARNING
ENSURE THAT ELECTRICAL LEADS AND
CONNECTIONS IN THE KETTLE BASE DO NOT
GET WET. REMOVE IF REQUIRED.
Important:- Retain drained water from kettle
jacket. The jacket was charged at the factory with
the correct amount of treated distilled water.
This water should be used to refill the kettle.
However, if water is lost during drainage see
Paragraph 3.3, Jacket Filling.
c) Remove thermostat control knob and disconnect
electrical leads.
d) Undo and remove thermostat retaining screws
which hold the thermostat to the kettle base
control compartment.