PART NUMBER 152797 REVISION
A
CALL 888-994-7636 FOR TECHNICAL SUPPORT
10
oven drain. During this time the condensate spray is turned on
for 90 seconds to cool the drain water.
During the remaining time, that is, most of the time, the con-
densate spray is turned off to conserve water.
11. Secret buttons
There is an unmarked button under the text display window,
about ½ inch above the O in groen. When this button is
pushed the TEMPERATURE display shows the actual measured
temperature in the cavity. This is useful for diagnosing heating
and cooling under normal operation.
During normal operation it is necessary to push only one button
at a time. Special features may be called by pushing a combina-
tion of buttons at the same time.
When STEAM, COMBO, and OVEN are pushed at the same
time the currently installed firmware version is shown in the red
TEMPERATURE display. This is useful to determine if the oven
contains the latest firmware release.
When STEAM, COMBO, OVEN, and CLEAN are pushed at the
same time (it takes two hands to do it) the diagnostics are
started. The first diagnostic is Diagnostics Exit. Push START to
exit the diagnostics and return to normal operation. Or rotate
the TIMER knob (the lower knob) to select the desired diagnos-
tics. When finished select Diagnostics Exit and push START.
Cleaning
It is best to clean the oven when it is at room temperature.
However, it may be cleaned right after cooking, that is, while
it is hot. First turn off whatever cooking mode is currently on
by pushing its button. For example, if the oven is in steam
mode (the STEAM indicator is on) push the STEAM button. The
indicator will go out showing that no cooking mode is currently
selected.
If the oven is off turn it on with the power switch. Push CLEAN.
The message OPEN DOOR AND REMOVE RACKS appears in the
display. Do what is says. When the door is open the message
changes to SPRAY CLEANER AND CLOSE DOOR. Do it. When
the door is closed the message changes to CLEAN MODE SOAK
TIME and the oven rests for two minutes to allow the cleaner
to work. A counter in the second line of the display shows the
number of seconds remaining in each timed cleaning step. Then
the rinse valve opens for one minute (message is CLEAN MODE
RINSE TIME) to flush the cleaner off the cavity walls. This is
followed by a two minute drain period (CLEAN MODE DRAIN
TIME) followed by another one minute rinse. When this is com-
plete the message CLEAN COMPLETE TIME LEFT is displayed
for a minute and the oven turns itself off.
If the oven is hot at the beginning of the soaking period the
message OPEN DOOR TO COOL OVEN is displayed. Do it. While
the door is open the message COOLINg is displayed. When the
oven has cooled sufficiently to allow it to continue the message
CLOSE THE DOOR is displayed. Do it. The cleaning cycle starts
with the message OPEN DOOR AND REMOVE RACKS.
At any time during the cleaning cycle the user may open the
door and spray more cleaner in the cavity. When the door is
closed the cycle starts over with the soaking period followed by
the two rinses.
Once a cleaning cycle has been started all other cooking modes
are inactive (locked out). The cleaning cycle must run to comple-
tion before the oven will operate in the cooking modes.
The oven may be turned off at any time during the cleaning
cycle. However, since the two rinses have not been complete
there is probably some cleaner on the cavity walls. When the
oven is turned on again it remembers that it was interrupted in
the middle of the cleaning cycle. The message is PUSH CLEAN
TO FINISH CLEANINg. Do it (no other cooking mode buttons
will operate). When the clean cycle is complete (all the cleaner
has been rinsed from the cavity walls) it shuts itself off. It can
then be turned on and operated in any mode.
Deliming
The oven may be delimed at any temperature. However, since
it is necessary to remove the steam lid from the inside of the
cavity the oven should be allowed to cool before starting the
procedure. First turn off whatever cooking mode is currently on
by pushing its button.
If the oven is off turn it on with the power switch. Push LIgHT.
While the LIgHT is on push CLEAN. The message OPEN DOOR
AND REMOVE STEAM LID appears in the display. This indicates
that the oven is in deliming mode. If the message OPEN DOOR
AND REMOVE RACKS appears it means that the LIgHT was not
on while CLEAN was pushed. You have another chance to put
the oven in delime mode. Push LIgHT again. While the LIgHT is
on push CLEAN. The STEAM LID message should appear.
Open the door and remove the steam lid from the bottom of
the cavity. The messages changes to ADD DELIMER AND CLOSE
DOOR. Water begins to fill the three reservoirs and the heaters
turn on. Pour 1/3 cup of delimer into each reservoir, 1 cup total.
Close the door.
The message changes to DELIME MODE TIME LEFT. The oven
operatIon
Содержание 2TRI-RES-20G
Страница 40: ...PART NUMBER 152797 REVISION A CALL 888 994 7636 FOR TECHNICAL SUPPORT 40 Wiring Diagram ...
Страница 41: ...PART NUMBER 152797 REVISION A CALL 888 994 7636 FOR TECHNICAL SUPPORT 41 Ladder Diagram ...
Страница 43: ......
Страница 44: ... ENDELL AVIS RIVE s ACKSON 3 s s AX GROEN COM 0 24 5 2 PART NUMBER 152797 REVISION A ...