Grizzly T32304, Руководство пользователя, Страница: 19 / 52

Belt Pulley
Motor Pulley
Figure 15. V-belt installed on pulley grooves
(saw body removed for clarity).
Belt Pulley
¼" Deflection
Motor Pulley
Figure 16. Testing for
1
⁄
4
" V-belt deflection.
Figure 13. Attaching motor to motor mount.
x 4
Figure 14. Attaching saw body to stand top.
x 3
Model T32304 (Mfd. Since 02/21)
-17-
6. Attach motor to motor mount with (4) M8-1.25
x 20 hex bolts, 8mm flat washers, 8mm lock
washers, and M8-1.25 hex nuts, as shown in
Figure 13.
Note: DO NOT completely tighten fasteners
until instructed to in
Step 9.
7. With help from an assistant, lift saw body and
place on stand (see Figure 14). Secure with
(3) M8-1.25 x 20 hex bolts, 8mm flat washers,
and 8mm lock washers through elongated
holes on stand top.
8. Fit V-belt into belt pulley groove, raise motor,
then fit V-belt into motor pulley groove (see
Figure 15).
9. Press down on center of motor to tension
V-belt, then tighten (4) hex bolts to secure
motor. Make sure that motor does not twist
while applying pressure.
Note: When properly tensioned, belt should
deflect about
1
⁄
4
" when moderate pressure is
applied to belt mid-way between upper and
lower pulley (see
Figure 16).
— If there is more than 1⁄4" deflection, loosen
(4) motor mount hex bolts, then repeat
Step 9 until properly tensioned.