Grizzly T10745, Руководство пользователя

Страница: 15 / 20

Model T10745
1
⁄
2
" x 18" Belt Sander -13
-
troubleshooting
symptom possible cause solution
tool does not start 1. power cord not connected.
2. power supply switched OFF,
breaker tripped, fuse blown, or
power supply is at fault.
3. oN/oFF switch at fault.
4. Motor at fault.
1. Connect power cord to
receptacle.
2. allow motor to cool com-
pletely and retry.
3. replace switch.*
4. test/repair/replace.*
tool stalls or is
underpowered. 1. Workpiece material not suit-
able for machine.
2. tool is undersized for task.
3. Motor overheated.
4. Extension cord too long or
diameter too small.
1. Ensure moisture content of
wood is below 20%.
2. reduce feed rate/press
with less pressure against
workpiece.
3. Clean motor, let cool, and
reduce workload.
4. do not use extension cord.
sanding results
diminish over time. 1. abrasive belt dull or damaged. 1. replace belt.
tool has vibration
or noisy operation. 1. Motor or component loose. 1. have qualified service per-
sonnel service tool.
tool overheating. 1. Motor forced to work too fast.
2. Belt dull or damaged.
3. Exhaust port blocked.
1. let tool work at its own
pace.
2. replace belt.
3. remove blockage from
exhaust port.
section 6: service
* solution should only be carried out by or under supervision of qualified service personnel.