Grizzly T10745, Руководство пользователя

Страница: 11 / 20

Model T10745
1
⁄
2
" x 18" Belt Sander -9
-
section 4: operations
Using the proper grit of coated abrasives
will provde the best results.
as a general rule, start with a coarse grit
size and move through finer grit sizes until
you achieve your desired finish.
use the list below to define paper grit
sizes:
• Extra Coarse ..............................12-20
• Very Coarse ...............................24-36
• Coarse .......................................40-50
• Medium ....................................60-100
• Fine ........................................120-180
• Very Fine ...............................220-280
• Extra Fine ..............................320-400
if you are not sure which grit to start with,
experiment on a hidden area on your
project.
the following
1
⁄
2
" x 18" aluminum oxide
sanding belts (sold in packs of 10) are
available through grizzly:
t25729—60 grit: Use for thickness sand-
ing and glue removal.
t25730—80 grit: Use for removing planer
marks and initial finish sanding.
t25731—100 grit: Use for removing plan-
er marks and initial finish sanding.
t25732—120 grit: Use for finish sanding.
t25733—150 grit: Use for finish sanding.
t25734—180 grit: Use for finish sanding.
t25735—200 grit: Use for finish sanding.
selecting abrasives
to install the sanding belt:
1. disCoNNECt
saNdEr FroM
poWEr!
2. tighten pivot knob shown in figure 3.
installing belt
figure 3. pivot knob location.
pivot Knob
3. While holding sander body, push
arm back until it clicks and locks (see
figure 4).
figure 4. locking arm.
arm
Body