Grizzly T10745, Руководство пользователя

Страница: 13 / 20

Model T10745
1
⁄
2
" x 18" Belt Sander -11
-
5. Wait until the sander gains full speed,
then press the belt lightly against the
workpiece.
6. When finished, turn sander OFF, and
unplug from receptacle.
accidental
start hazard!
disconnect before
service or tool
changes.
eye/lung/ear
inJury hazard!
Wear protective
equipment when
using this tool.
electrical shocK hazard!
only use sander for dry sanding.
never use sander for wet sanding!
to operate sander:
1. loosen the pivot knob, turn arm to
desired angle, then tighten pivot knob.
2. Connect plug to a matching receptacle.
3. secure workpiece so it does not move
during operations.
4. hold sander with both hands and push
oN/oFF switch to "
I
". turn variable
speed dial to set desired belt speed
(see
figure 9).
figure 9. sander controls.
oN/oFF
switch
pivot Knob
Variable
speed
dial
tips
For best results, use a low speed setting
with a fine grit, or when sanding plastics,
ceramics, or removing painted surfaces.
Use a high speed setting with a coarse grit,
and when removing a lot of material.
When sanding wood, work evenly in the
same direction as the grain. Keep the sand-
er moving so the finish stays consistent.
sanding across the grain may be neces-
sary to remove rough spots. this should
be done carefully, as it can produce cross-
grain scratching that may be difficult to
remove.
Change the belt as soon as the grit
becomes dull. to extend the life of the belt,
only apply as much force as necessary.
recommended uses
the Model t10745 is designed to sand
and grind wood, iron, and plastic. it can be
used for:
• sanding flat surfaces, corners, and
inner openings.
• Chamfering and deburring metal.
• removing paint, rust, and weld splat-
ters.
• sharpening blades.
operating sander