Grizzly MTS 43 AC E2, Перевод оригинальной инструкции по эксплуатации, Страница: 122 / 244

122
GB
5. Remove the protective cover (15) and
pull the protective cap over the thread
cutter (14).
Filling with Fuel (Picture 8)
Always ensure good ventilation
when handling fuel.
Do not smoke when filling with
fuel and keep away from any
heat sources. Never fill with fuel
when the engine is running.
Open the tank cap carefully, so
any excess pressure present can
be relieved slowly.
Start the equipment min. 3 m
away from the fuel filling loca -
tion. Risk of fire or explosion in
case of non-observance.
Use only the fuel mix recommended
in the instructions. The fuel mix ages.
Therefore, do not use fuel mix that
is older than 3 months. In case of
non-observance, the engine can be
damaged and the guarantee will be
invalidated.
Avoid direct skin contact with
petrol and the inhalation of petrol
fumes. Health hazard!
The equipment is fitted with a
two-stroke engine and therefore
operated exclusively with a mix
of petrol and two-stroke engine
oil in the ratio 40:1.
• Use quality unleaded petrol with an
octane rating of at least 90.
• Optimum performance will be
achieved with the use of the Grizzly
two-stroke engine oil designed specifi -
cally for the equipment. If this is not
available, use super oil for air-cooled
two-stroke engines.
1. Mix petrol and oil in the fuel mixing
can (27) included in the delivery:
Fill with petrol (gas) up to the “585.36”
mark.
Fill with two-stroke engine oil (oil) up
to the “600” mark.
Close the container and shake care-
fully.
2. Unscrew the tank cap (37) and pour
the fuel mix into the fuel tank (2).
Wipe away fuel residues around the
tank cap and reclose the tank cap.
27
37
2
pic. 8
Initial Operation
Warning! Before initial opera-
tion of the equipment, it must be
checked that the condition is safe
for operation. If there is any doubt,
do not start the equipment.
Observe the following points in particular:
• Check the cutting tools for damage and
wear.
• Correct installation of the cutting head
• Easy movement of all switches
• Secure sit of the spark plug connector.
If the connector is loose, sparks can be
formed and thus ignite any leaking fuel-
air mix.
• Ensure the handles are clean in order to
be able to guide the equipment safely.
• All safety and protective devices must be
properly installed and in place before the
equipment can be started.