Grizzly G1014Z, Руководство пользователя

Страница: 26 / 64

-24-
Model G1014Z/G1014ZX (Mfd. Since 08/22)
23. While looking through the access hole on the
side of the cover, rotate the plate and tighten
each of the set screws to secure the plate to
the drive shaft (see
Figure 31).
25. Install the 2
1
⁄
2
" black plastic dust port onto the
pulley cover with (4) 10-24 x
3
⁄
8
" Phillips head
screws, 10-24 hex nuts, and #10 flat wash-
ers, as shown in
Figure 33.
Figure 33. 2
1
⁄
2
" dust port installed.
x 4
Dust Port
Pulley
Cover
24. Peel off the backing on the 9" PSA (pres-
sure sensitive adhesive) sanding disc, make
sure the cast iron plate is clean, and install
the sanding disc onto the plate, as shown
in
Figure 32. Make sure the sanding disc
adheres completely flat against the plate.
Figure 32. Installing sanding disc onto cast iron
plate.
Figure 31. Securing plate to drive shaft.
Set Screws
Access Hole
26. Secure the pulley cover with the thumb knob.
27. Loosen the (2) set screws on the back of
the base, slide the table support rod into the
base, making sure the flat of the rod faces the
set screws, then tighten the set screws, as
shown in
Figure 34. The rod should protrude
about 6
1
⁄
4
" from the side of the base.
Figure 34. Installing table support rod.
6
1
⁄
4
"
Table
Support
Rod