Grizzly G0894, Руководство пользователя

Страница: 38 / 48

-36-
Model G0894 (Mfd. Since 05/19)
Symptom Possible Cause Possible Solution
One or more axes
only move in one
direction. 1. Circuit board and motor connection loose.
2. Incorrect machine parameters.
3. Circuit board at fault.
4. Stepper motor at fault.
1. Inspect connections and ensure all are tight.
2. Verify machine parameters (
Page 22).
3. Inspect/clean plugs and sockets and retry. Replace
if bad.
4. Inspect/clean plugs and sockets and retry. Replace
if bad.
One or more axes
will not move. 1. Direction wire and pulse wire in wrong
place on circuit board.
2. Stepper motor disconnected.
3. Stepper motor at fault.
4. No pulse signal output from circuit board.
1. Rewire.
2. Reconnect.
3. Inspect/repair/replace.
4. Replace circuit board.
Controller screen is
dim. 1. Power supply disconnected or damaged.
2. Power supply voltage too high for
controller.
3. 50-pin cable at fault.
4. Display at fault.
1. Inspect/replace power supply from circuit board.
2. Use correct power supply. High voltage may
damage controller; replace if needed.
3. Inspect/clean plugs and sockets and retry. Replace
if bad.
4. Replace controller.
Controller screen
is blank, flickers, or
restarts. 1. Faulty controller connection.
2. Incorrect power supply voltage or circuit
size.
3. Display or controller at fault.
1. Inspect/clean plugs and sockets and retry. Replace
if bad.
2. Ensure correct power supply voltage and circuit
size.
3. Replace controller.
Controller screen
says spindle is
ON
when spindle is OFF
and spindle is
OFF
when spindle is ON.
1. Wrong connections at circuit board. 1. Rewire.