Model G0860/G0861/G0862 (Mfd. Since 10/18)
-23-
16. Attach 2" swivel casters to collection drum, as
shown in
Figure 18, using (1)
5
⁄
16
"-18 hex nut
on each.
17. Adjust pre-installed flange nut and hex nut
(see
Figure 18) until drum rolls evenly with-
out rocking or wobbling, then tighten both
nuts to secure caster in place.
18. Place vacuum ring inside collection drum with
smaller side of ring facing down, as shown in
Figure 19.
Note: During operation, this ring and the
vacuum connection to the cyclone funnel will
prevent the collection bag from collapsing or
being pulled up into the cyclone.
12. Place (2) hose clamps around flexible hose,
then slip hose onto collection drum lid and
tighten clamp (see
Figure 17).
13. With collection drum lid mounting brackets
facing up, orient lid so dust port, flexible hose,
and spring brackets align (see
Figure 17).
14. Attach flexible hose to cyclone funnel and
secure with (1) hose clamp (see
Figure 17).
15. Connect ground wire to spring bracket stud,
then secure lid and ground wire using (4)
5
⁄
16
"-
18 flange nuts (see
Figure 17).
Figure 19. Inserting vacuum ring into collection
drum.
Vacuum Ring
11. Using fasteners attached to spring bracket,
place upper end of drum lock handle over
outer stud on spring bracket, then attach lock
handle link to lower hole on lock handle (see
Figure 16).
Figure 16. Lock handle attached to spring
bracket and lock handle link.
Lock
Handle
Link
Drum Lock Handle
Outer Stud
(1 of 2)
Spring
Bracket
Figure 18. Cut-away illustration of 2" swivel
caster attachment to collection drum.
Pre-Installed
Flange Nut
Hex Nut
Figure 17. Collection drum lid and related
components installed.
Cyclone
Funnel
Flexible
Hose
Collection
Drum Lid
Mounting
Bracket
Spring
Bracket
x 4
Attach Ground
Wire Here
