Grizzly G0736, Руководство пользователя

Страница: 51 / 72

Model G0736/G0737 (Mfd. Since 3/14)
-49-
Calibrating Table Tilt
Scales
The table tilt scales must be calibrated to the
blade to ensure that they are accurate.
Tools Needed Qty
Hex Wrench 10mm ............................................. 1
Wrench or Socket 17mm .................................... 1
Phillips Screwdriver ............................................ 1
Square ................................................................ 1
To calibrate the table tilt scales:
1. DISCONNECT BANDSAW FROM POWER!
2. Adjust the table tilt to 0° from front-to-back
and side-to-side (refer Adjusting Table Tilt
on
Page 28).
3. Place the square on the table and up against
the side of the blade (not against the teeth),
as shown in
Figure 63. The square should
rest evenly on the table and up against the
blade.
Figure 63. Checking side-to-side table tilt with
blade.
4. Check the scale pointer underneath the right
side of the table—it should be pointing to the
0° mark.
— If the scale pointer does not point directly to
the 0° mark, loosen the Phillips head screw
on the pointer, adjust the pointer to point
directly at the 0° mark, then re-tighten the
Phillips head screw.
5. Repeat Steps 3–4 with the square against
the back edge of the blade and using the
front-to-back tilt controls under the table.
— If the square does not rest evenly on the
table and up against the blade, adjust the
table tilt until it does.