Grizzly G0736, Руководство пользователя

Страница: 22 / 72

-20-
Model G0736/G0737 (Mfd. Since 3/14)
5. Open the upper wheel door.
6. Watch the position of the blade on the wheel
as you rotate the upper wheel by hand sev-
eral times.
— If the blade rides up against the wheel
flange without pressure and does not wan-
der, then no further adjustments are need-
ed. Skip ahead to
Step 9.
— If the blade does not ride up next to the
wheel flange or it wanders, proceed with
the next step.
7. Turn the tracking knob a small amount, then
rotate the upper wheel by hand several times
while watching the blade position on the
wheel
Note: Turn the knob clockwise to make the
blade move toward the wheel flange, and
counterclockwise to move away from the
wheel flange.
8. Repeat Step 7 until the blade rides evenly
next to the wheel flange without pressure and
without wandering across the wheel.
9. Re-install the V-belt and secure both doors.
Adjust the blade tracking by rotating the knob
shown in
Figure 18.
If you cannot get the blade to properly track,
the wheels may be out of alignment. Refer
to Wheel Alignment on Page 46 for detailed
instructions on checking and adjusting.
When the tracking knob is rotated, the bottom of
the upper wheel moves in or out, which changes
how the blade tracks.
To adjust blade tracking:
1. DISCONNECT BANDSAW FROM POWER!
2. Make sure the blade is properly tensioned, as
instructed on the previous page.
3. Open the rear motor access door.
4. Roll the V-belt off the lower wheel pulley (see
Figure 19). This will allow the wheels to turn
freely by hand.
Figure 18. Location of the blade tracking knob.
Blade
Tracking
Knob
Figure 19. V-belt to remove in order to allow the
wheels to spin by hand.
Lower Wheel
Pulley
Remove this
belt.