Grizzly G0736, Руководство пользователя

Страница: 26 / 72

-24-
Model G0736/G0737 (Mfd. Since 3/14)
Test Run
Once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation. The test run consists
of verifying the following: 1) The motor powers up
and runs correctly and 2) the STOP button safety
feature works correctly.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
Troubleshooting on Page 44.
If you cannot find a remedy, contact our Tech
Support at (570) 546-9663 for assistance.
To test run the machine:
1. Make sure you understand the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
2. Make sure all tools and objects used during
setup are cleared away from the machine.
3. Push the bandsaw STOP button in, then twist
it clockwise so it pops out. When the STOP
button pops out, the switch is reset and ready
for operation (see
Figure 29).
Figure 29. Resetting the STOP button.
4. Make sure the blade is properly tensioned
and tracked (refer to Tensioning & Tracking
Blade on Page 19) and the blade guides
are positioned correctly (refer to
Adjusting
Blade Guide Assemblies on Page 21).
5. Insert the key into the bandsaw power switch
on the control panel (see Figure 30), and turn
it to the Unlocked position to enable power to
the bandsaw motor.
6. Verify that the bandsaw is operating correctly
by pushing the bandsaw START button to
begin blade rotation.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— Investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
7. Use the variable speed handwheel below the
table to change the blade speed and verify
that the digital speed readout responds to the
changes.
8. Adjust the blade speed to the minimum
speed, then press the STOP button and allow
the blade to come to a complete stop.
Figure 30. Bandsaw control panel.
Bandsaw
STOP Button
Speed
Readout
Bandsaw
Power
Switch
Bandsaw
START
Button