Grizzly G0736, Руководство пользователя

Страница: 38 / 72

-36-
Model G0736/G0737 (Mfd. Since 3/14)
Note: To make a proper blade weld, the ends
of the blade must be evenly butted together
during the welding process. If necessary, use
the grinder to square up the ends or remove
any teeth that are in the welding zone (see
Figures 43–44).
Figure 43. Using the grinder to square up the
blade end.
Welding Zone
Grind Off
Figure 44. Blade ends and welding zone.
3. Pull the welding guard up and loosen the
welding clamps by pulling the lock levers
down (see
Figure 45).
4. Position the back of one blade end evenly
against the back of the welding clamp so that
the end is midway between the two clamps,
then rotate that lock lever all the way up to
hold the blade end in place.
5. Set the clamping pressure dial (see Figure 46)
to "0".
Note: As the blade material melts to form the
weld, pressure is applied to the joint by the
welding clamps. The correct amount of pres-
sure will be set with the clamping pressure
dial in a later step.
Figure 45. Blade end properly position in
welding clamp and locked in place.
Welding
Clamp
Blade
End
Lock
Lever
Figure 46. Blade ends in correct position for
welding.
Clamping
Pressure
Dial
Annealing
Button
Blade Ends
Weld Button