-6-
G0620 Main Control Panel
Blade Height
Adjustments
The blade height can be adjusted manually or
numerically by entering in the desired blade
height. The adjustment can be cancelled at any
time by pressing the Stop key.
Figure 6
shows the keys used during the blade
height adjustment procedures in this section.
Numerically Adjusting Blade Height
You can enter a desired blade height with the
number keys and the blade will automatically
adjust to that height.
To adjust the blade height automatically with
numerical input:
1.
Press the blade height control key.
The indicator light on the key shines to tell
you that the control panel is ready to accept
your input.
2.
Enter your numerical input with the number
keys. As you press the keys, the display will
flash the numbers you have entered. If you
press a wrong number or make a mistake
with your input, press the clear
key and
start over.
Example:
If you want the blade height to be
2.25", then you would press the following
keys: , and the display would look
similar to
Figure 7
.
Note:
It may be necessary to enter a zero
first if your numerical input is less than one.
����
�
�
����
Figure 7.
Example of 2.25" entered into blade
height display.
3.
Press the Start key.
The control panel accepts your input, moves
the blade to your desired height, and the
indicator light on the blade height key stops
shining.
Manually Adjusting Blade Height
The blade height can be manually adjusted using
the plus
and minus
keys. In some cases,
manual adjustments can save time by eliminating
measurements. For example, if you want to adjust
the blade height a little higher than the workpiece,
you can place the workpiece next to the blade and
use the manual controls to adjust the blade height
as desired.
To adjust the blade height manually:
1.
Press the blade height control key.
The indicator light on the key shines to show
that the control panel is ready for input.
2.
Use the plus or minus key to manually
position the blade height. (Bump the keys for
small adjustments and hold the keys down for
large adjustments.)
3.
When finished, press the Stop key, so the
indicator light stops shining.
�
�
�
����
Figure 6
. Keys used in blade height adjustment
procedures.
