G0620 Main Control Panel
-5-
MM/Inch Selection
The control panel can display units in millimeters
or inches.
To toggle the display between mm and inches,
press and hold the mm/inch
key (
Figure 4
)
until the new unit of measure shows on the control
panel.
Note:
The indicator light on the key shines next to
the unit of measure selected.
Figure 4.
Pressing mm/inch key to toggle the
displayed unit of measure.
�
�
�
����
Press and
Hold
Figure 5
shows the keys used to adjust the scor-
ing blade, as discussed in this procedure. You
can press the Stop
key at any time to cancel
the operation.
�
�
�
����
������
���������
Figure 5.
Scoring blade controls keys.
Scoring Blade Height
1.
Press the scoring blade height
control
key.
The indicator light on the key shines to show
the selected control is active.
2.
Use the plus
and minus
keys to posi-
tion the scoring blade. Typically, the scoring
blade is only adjusted about
1
⁄
4
"–
1
⁄
2
" above the
table.
3.
When finished, press the Stop key, so the
indicator light stops shining.
Scoring Blade
Adjustments
Scoring Blade Alignment
1.
Press the scoring blade alignment
control
key.
The indicator light on the key shines to show
the selected control is active.
2.
Use the plus
and minus
keys to align
the scoring blade with the main blade. (Use a
straightedge or the rip fence as a guide.)
3.
When finished, press the Stop key, so the
indicator light stops shining.
