G0620 Main Control Panel
-13-
Blade Tilt Calibration
Performing this procedure ensures that the blade
tilt displayed in the digital control panel is accu-
rate.
The calibration is a simple procedure that only
takes minutes.
Note:
You can stop the calibration process at any
time by pressing the Stop key.
Tools Needed
Qty
45° Square ........................................................ 1
To calibrate the blade tilt:
1.
Move the overhead blade guard out of the
way.
2.
Raise the main blade as high as it will go.
3.
Tilt the blade to 45°.
4.
Place the 45° square flat on the table, push it
up against the blade (make sure it does not
contact a carbide tooth), and examine how
the square fits against the blade.
— If the square fits flat against the blade, then
the blade tilt calibration is already correct.
— If the square does not fit flat against the
blade (you can see a gap between the
square and the blade), then continue to the
next step to calibrate the blade tilt.
5.
Press the blade tilt key. The indicator light
on the key shines to show that the control
panel is ready to accept input.
6.
Use the plus or minus key to manually
position the blade tilt so it fits flat against the
45° square while the 45° is flat against the
table, as shown in
Figure 25
.
7.
Press the number and keys to enter 45
degrees into the display.
8.
Press and hold the input confirmation
key
until the display stops flashing.
The indicator light stops shining to tell you
that the control panel will no longer accept
input for the blade height.
9.
Return the blade position and blade guard
back to their original position.
�����
����������
�����
Figure 25.
45° Square flat against table and
blade.
