4.4 Channels indication
5.0 AUTOMATIC MODE
1. When the ACROBAT PE 575 unit is not connected to a DMX controller it can operate to
music while changing to different pre-programmed scenes sequences. The music beat is recei-
ved by the on-board microphone located on the main PCB.
2. More ACROBAT PE 575 units can be set to ‘SLAVE’option to follow the ‘MASTER’ unit
in synchrony. The ‘MASTER’ unit shall have option 4 set to (H); its microphone will follow
the music beat and will guide the rest of the units of the chain to the same rythm change
through the pre-programmed scenes. Option 4 of all ‘SLAVE’ units connected to the
‘MASTER’ one shall be set to (L) and their DMX address must be 1.
The line terminal is a resistor fitted between the 2 Signal Pins (2 and 3) at the end of the DMX
line. This is to avoid the defective functioning of the DMX line itself. A 120 Ohm/1W resistor
is suggested.
14
Master
Slave
Slave
Slave
Line
terminal
