Grill'D Soul Stell, Инструкция по установке и эксплуатации

Страница: 8 / 28

8
•
In case there is a hot water tank, water shall be drained from the tank every time
after termination of the heater operation, if the room temperature drops below + 5 °С
during interruptions of the heater operation.
2.7. Water in the sauna
The water poured onto the stones shall be clean tap water. Ensure the water quality. Water
with a high content of iron, salt, humus, or lime can lead to early corrosion of the heater
elements. For example, seawater will lead to rapid corrosion of the stone heater. The tap
water quality shall meet the following requirements:
‒
humus content <12 mg/liter;
‒
iron content <0.2 mg/liter;
‒
calcium content <100 mg/liter;
‒
manganese content <0.05 mg/liter.
IMPORTANT! Water shall only be poured onto the stones. If water is poured on heated
steel surfaces, they can be deformed due to high differential temperature.
IMPORTANT! It is prohibited to use solution of salt to generate steam during operation:
pouring it into the closed stone heater (if available), pouring it onto outer stone heater
and the heater metal.
2.8. Maintenance
Routine maintenance
of the chimney, heater and its parts is the key to their efficient and
safe operation, your safety and safety of your close ones!
IMPORTANT! Carry out maintenance works on the heater and chimney only after their
complete cooldown.
IMPORTANT! Take measures recommended for safety. Use personal protective equipment
required for such works.
The heater and chimney shall be cleaned of soot before the commencement of the heating
season, as well as during the entire heating season at least once every three months.
Cleaning to be performed mechanically. Use special devices, tools and machines (brush,
cleaner, scraper, sinker, vacuum cleaner, etc.). The selection of the necessary tools is made
based on the needs of the cleaning works. Cleaning the flue channels of the heater is carried
out through the cleanout hole after removing the cap (refer to Appendix 2): unscrew nuts,
remove the cap and baffle plates. After cleaning the flue channels, install the cap and baffle
plates, makeup and tighten the nuts.
Soot in the chimney accumulated due to poor cleaning, as well as incomplete combustion of
fuel, can break into flames.
Procedure in case of fire in the chimney:
1. Close the door, the ash drawer, and the flue damper (if available).
2. Call the local fire department.
3. Do not attempt to extinguish the fire with water.
4. After an ignition of soot, a specialist shall check the heater and the chimney for the
possibility of further operation.
IMPORTANT! The use of cleaning log (briquettes), homemade compounds creating high
temperature in the heater firebox and chimney, is prohibited for the purposes of burning
the soot deposited in them.
The stones deteriorate with time as the heater is operated, this is why it is necessary to
turn them over and reposition in the stone heater at least once a year, when the heater is