Grill'D Soul Stell, Инструкция по установке и эксплуатации

Страница: 7 / 28

7
2. Put 3-4 logs on the grate in such a way as to ensure free access of air to the combustion
area, namely: lay the firewood loosely, adjust the ash drawer gap to be within 50 mm.
In heater models of Short version firewood can be loaded vertically.
3. Ignite the firewood loaded into the firebox. The preferred ignition method is using birch
bark, wood chips and other natural materials, or using paper or throwaway newspapers.
4. Close the door.
5. Partly close the ash drawer after heating up of the chimney and development of
stable draft (usually after burning of the first load of firewood, approximately in 30-45
minutes), leaving a gap within 10 mm. It is necessary to constantly ensure sufficient
draft, while avoiding the development of excessive one (it can manifest itself as
humming of the heater, too erratic flame), that leads to heating of the firebox red hot,
which significantly reduces the heater service life. Control the draft by adjusting the ash
drawer gap.
6. Close the ash drawer completely after the air in the bath house heats up to a
temperature of 60-70
о
С.
7. As a rule, 1-2 logs are enough to maintain the temperature in the steam room. In case
the temperature decreases, open the ash drawer and adjust the gap within 3-10 mm in
order to kindle the firewood (it takes more time, when the ash drawer is closed), and
close the ash drawer afterwards. If the temperature keeps decreasing, then adjust the
ash drawer gap within 3-10 mm and keep it until the temperature reaches 60-70оС,
then close the ash drawer. Bear in mind, that excessive heating (for example, several
full loads in a row) leads to overheating and shortens the heater and chimney service
life, and can also cause a fire.
8. When additional firewood is required, open the door smoothly, without jerks. Load the
firewood and close the door. Adjust the draft.
9. After the completion of bathing procedures prepare the room and the heater for
closing: they are to be aired and dried. To do so:
• Put 4-5 logs into the heater firebox, kindle them. Set the ash drawer gap to be
approximately 10 mm. Open the hatches/windows, that serve for airing, and the door in
order to develop a small draft.
Note: the air and the bath house to remain heated, the air to move barely noticeably,
i.e. it shall be quite warm or even hot in the bath house (up to 60-70оС).
• Heat up the bath house in this mode, the firewood will burn in approximately 30-45
minutes. Completely close the ash drawer after formation of active red coals. Close the
hatches/windows and the door, leave the bath house until next use.
• The room and the heater to be periodically checked after such stokings: there shall be
no water or moisture in the stone heater, the stones shall be dry, and so shall be the
boards in the rooms. If the rooms and the heater did not dry thoroughly, it is allowed to
carry out additional stoking of the heater with a completely closed ash drawer.
IMPORTANT! The following is prohibited:
‒
using explosive, toxic, highly flammable substances, paints, solvents, gasoline, etc., to
ignite the firewood;
‒
operating the heater at a constant excessive draft in the firebox.
IMPORTANT!
•
Partial burning out of heat-resistant enamel is possible on the most thermally loaded
elements of the heater during operation, which is not a manufacturing defect.
•
The firebox metal may become slightly deformed during operation, which is not a
manufacturing defect provided the integrity of weld joints is preserved.