Grill'D Soul Stell, Инструкция по установке и эксплуатации

Страница: 14 / 28

14
1. Install the heater on the place of permanent operation.
2. Install a water tank, if any. Keep in mind the requirements of its operations manual.
3. A valve can be installed on the connecting pipe, if additional adjustment of draft is
necessary. Install, if any.
4. Install all the necessary components of the outside chimney.
5. Insert the connecting pipe into the outside chimney.
6. Connect the heater with the pipe inserted into the outside chimney.
7. Ensure that all the pipe connections and the heater connection are relia.
Note: when installing the chimney from the heater directly through the ceiling and roofing
system, all the elements are installed consecutively.
Note: when applying additional vertical load on the heater structure, such as: installing an
additional volume of stones, installing a chimney, installing a water tank, etc., the maximum
permissible load shall be considered. It shall be equivalent to the sum of a filled water tank
with a volume of 70 l, max, and two heat-insulated chimney modules with a length of one
meter.
Use special unloading support platforms to reduce load, when installing a steel chimney.
The mass of the vertical part of the chimney supported by the heater, shall not be greater
than the maximum permissible one. Further, you need to install an unloading support
platform and using it, continue the chimney installation.
IMPORTANT! Familiarize yourself with the manufacturer’s detailed instructions on the safe
distances and installation of steel chimney elements, as well as the water tank.
IMPORTANT! If there is a protective shield around the stone heater, the chimney insulation
shall start at the level of the top edge of the shield or lower.
Some installation options are depicted in Figure 6.
The procedure for installing the pipe at an angle: