Grill'D Dubravo 180 Long, Инструкция по установке и эксплуатации

Страница: 9 / 28

9
2) Fault: The sauna room is not heating up.
Possible cause:
• The sauna room is too large for the heating capacity of the heater.
• Thermal insulation of the room is not in compliance with the requirements.
• Insufficient chimney draft.
• Low quality or wet combustion material.
• Blockage in the chimney or flue channels of the heater.
Troubleshooting methods:
• Check that the heater capacity matches the size of the sauna (section 1).
• Check the thermal insulation of the room (section 1).
• Check combustion material for compliance (paragraph 2.4).
• Perform maintenance (paragraph 2.8).
3) Fault: The stones in the stone heater do not heat up.
Possible cause:
• The sauna room is too small for the heating capacity of the heater. The room is heating
up faster than the stones.
• Insufficient chimney draft.
• Low quality or wet combustion material.
• Blockage in the chimney or flue channels of the heater.
• The stones are laid incorrectly.
Troubleshooting methods:
• Check that the compliance of the heater capacity against the sauna size (section 1).
• Check combustion material for compliance with the requirements (paragraph 2.4).
• Perform maintenance (paragraph 2.8).
• Inspect the stone heater for compliance with the requirements (paragraph 2.5).
Remove stone chips and replace them with intact stones. Replace the stones with
diameters less than the ones specified in Table 1 with larger ones.
4) Fault: The operating mode of the heater cannot be controlled during wind /heater firing/
low chimney draft during operation. Smoke partly escapes through the firebox door. Smoke
enters the sauna.
Possible cause:
• Blockage in the chimney or flue channels of the heater.
• The chimney height is not sufficient or the chimney is located next to a high obstacle.
• There is cold air in the chimney; the chimney has not heated up.
• Low quality or wet combustion material.
• The chimney is installed incorrectly.
Troubleshooting methods:
• Perform maintenance (paragraph 2.8).
• Extend the chimney stack height.
• Insulate the chimney stack with a non-combustible heat-insulation material.
• Select a heat-insulated chimney stack.
• Remove ash from the ash drawer.
• Check combustion material for compliance with the requirements (paragraph 2.4).
• Ensure supply of a sufficient volume of combustion air.
• Check the correctness of chimney installation and/or compliance with the
manufacturer’s requirements; trust the installation and disassembly of the chimney
only to qualified specialists.