Grill'D Dubravo 180 Long, Инструкция по установке и эксплуатации

Страница: 14 / 28

14
Note: when applying additional vertical load on the heater structure, such as: installing an
additional volume of stones, installing a chimney, installing a water tank, etc., the maximum
permissible load shall be considered. It shall be equivalent to the sum of a filled water tank
with a volume of 70 l max, and two heat-insulated chimney modules with a length of one
meter.
Use special unloading support platforms to reduce load, when installing a steel chimney.
The mass of the vertical part of the chimney supported by the heater, shall not be greater
than the maximum permissible one. Further, you need to install an unloading support
platform and using it, continue the chimney installation.
IMPORTANT! Familiarize yourself with the manufacturer’s detailed instructions on the safe
distances and installation of steel chimney elements, as well as the water tank.
IMPORTANT! If there is a protective shield around the stone heater, the chimney insulation
shall start at the level of the top edge of the shield or lower.
Some installation options are depicted in Figure 6.
4. WARRANTY
The warranty period for the Product is 5 years, it applies to the integrity of weld joints.
The warranty period for the entire Product is 1 year. The warranty is valid from the date of
purchase of the Product by the Consumer.
The service life of products while meeting the requirements of the operation manual and
the installed combustion chamber reinforcement is at least 2000 hours, while without
combustion chamber reinforcement it is 1500 hours.
Note: In case of periodic non-commercial use of the product, the time of operation is as a
rule 4 hours per week or roughly 200 hours per year.
If the Consumer detects a non-compliance of the Product with the specified properties, the
Consumer has the right to address a claim to the Company that sold the Product. However,
the Company has the right to contact the Manufacturer to resolve issues regarding the
Claim. The Manufacturer undertakes to improve
the entire Product or its part (as decided by the Manufacturer) free of charge, replace the
entire Product, its components, parts, compensate for the damage in any other way (as
agreed with the Consumer), if the defect occurred during the warranty period or due to the
Manufacturer’s fault.
Should the Consumer make alterations to the entire Product, its component(s), part, then
warranty obligations do not apply to the Product. Thereafter, the warranty does not apply to
elements that are subject to periodic replacement during operation.
The Product warranty is not provided in case of violation by the Consumer of the
requirements specified in the Operation Manual, technical requirements for installation and
operation of the Product. The above violations by the Consumer release the Manufacturer
from responsibility.