Grill'D Dubravo 180 Long, Инструкция по установке и эксплуатации

Страница: 8 / 28

8
IMPORTANT! Carry out maintenance works on the heater and chimney only after their
complete cooldown.
IMPORTANT! Take measures recommended for safety. Use personal protective equipment
required for such works.
The heater and chimney
shall be cleaned of soot before the commencement of the heating
season, as well as during the entire heating season at least once every three months.
Cleaning to be performed mechanically. Use special devices, tools and machines (brush,
cleaner, scraper, sinker, vacuum cleaner, etc.). The selection of the necessary tools is made
based on the needs of the cleaning works. Cleaning the flue channels of the heater is carried
out through the cleanout hole after removing the cap (refer to Appendix 2): unscrew both
nuts, remove the cap. After cleaning the flue channels, install the cap, makeup and tighten
the nuts.
Soot in the chimney accumulated due to poor cleaning, as well as incomplete combustion of
fuel, can break into flames.
Procedure in case of fire in the chimney:
1. Close the door, the ash drawer, and the flue damper (if available).
2. Call the local fire department.
3. Do not attempt to extinguish the fire with water.
4. After an ignition of soot, a specialist shall check the heater and the chimney for the
possibility of further operation.
IMPORTANT! The use of cleaning log (briquettes), homemade compounds creating high
temperature in the heater firebox and chimney, is prohibited for the purposes of burning
the soot deposited in them.
The stones deteriorate with time as the heater is operated, this is why it is necessary to
turn them over and reposition in the stone heater at least once a year, when the heater is
frequently operated. Remove the destroyed stones and their parts from the stone heater,
replace them with new ones. Before laying the stones, clean the heater with a wet cloth.
The ash drawer shall be cleaned at all times before heating, so that the combustion air
passing through the ash drawer to cool the grate, thereby increasing its service life. If there
is a thermal glass door, use soft cleaning waste with special agents for cleaning heat-
resistant glass of fireplaces and heaters in accordance with the application instructions.
Please, obey fire safety rules!
2.9. Typical faults and troubleshooting methods
1) Fault:
Odors appear during the heater operation.
Possible cause:
• There is leftover industrial oil on the heater surface, or/and the odor comes from heat-
resistant enamel.
• When heating up, the heater can enhance the odors present in the air, even if their
source is not the sauna itself or the sauna heater. Such sources, for example, can be
surfaces treated with paint, oil, glue and other materials.
Troubleshooting methods:
• Stoke the heater in accordance with paragraph 2.3.
• Select appropriate materials for treatment of the surfaces in the sauna; use them in
accordance with the application instructions.