H84.0.15.6C-01
Operating manual ResOx 5695
Page 14 of 22
_____________________________________________________
_____________________________________________________________________________
9.3 Evaluation of sensor state
“
ELE[
“
Watch sensor state: press
shortly once, display shows
”
xx%
ELE[
“
for a short time.
This shows the sensor state resulting of the last successful calibration carried out.
The evaluation is displayed in 10 % steps: 100% means optimal sensor condition. Lower values are
indicating that the sensor life time will be reached soon.
But also an erroneous pressure may be the cause of low valuation values.
10 Data logger
10.1 General
The device supports two different logger functions:
”
FVNC
STOR
“:
Manual recording by key press
.
Additional input of measuring point (L-Id) is needed.
”
FVNC
(Y(L
“:
Automatic recording at intervals of set cycle time.
A recording consists:
- Oxygen concentration in Vol. O
2
or ppm.
- Oxygen saturation in % oder oxygen partial pressure in hPa or mmHg.
- Temperature in °C oder °F.
- Absolute pressure in hPa abs oder mmHg abs.
- Measuring point L-Id (nur bei
”
FVNC
STOR
“
).
- Time and date of the recording.
For the evaluation of the data the software GSOFT3050 (version V3.0 or higher) has to be used. The
software also allows easy configuration and starting of the logger.
When the logger is activated (
”
FVNC
STOR
“
or
”
FVNC
(Y(L
“
) the hold function is no more available, the key
”
store
“ is solely used for the operation of the logger functions.
10.2 Recording manual
”
FVNC STOR
“
10.2.1 Recording the measured values manually
1000 measurements can be saved if the logger function
”
FVNC
STOR
“
where chosen, see chapter 5
Configuration.
Press shortly:
Recording is stored. It will be displayed for a short time
“
ST.
XX
“
XX
represents the number of the recording.
or
Measuring point choice
A number of
0…19999 or text, who is assigned to a measurement point number of
1…40, (comfortable assignment of texts can be done with gratis software GMHKonfig)
Confirm input
Logger memory full
10.2.2 Call manual recording
Saved recording can be selected with PC-Software GSOFT3050, also considered in the display device.
Press 2 seconds:
The display is shown:
If recording are saved
is appeared. Without recording the configuration menu
is appeared.
Last recording
Press again
Change between the data of the recording (O
2
-concentrate, O
2
-parial pressure, absolute
pressure, date and time)
or
Changing the measurement