13
P0803466-00 v.2.0
KNOW YOUR ZERO TURN MOWER
CONTROL PANEL
Left control panel ( with operator seated ) (See Figure 2.)
• Storage area:
Two storage areas offer a convenient place to store your cell phone or MP3 player.
• USB port:
The USB charging port provides charging power of 5 Volts DC at up to 2 amps for your
cell phone, MP3 player, or other USB devices. Consult the owner’s manual for your device for
specific charging requirements. Connect one end of a USB cable (not provided) to your device and
the other end to the USB charging port on the mower, to begin charging your device.
NOTE: The USB port is only powered when the start key is in the ON position.
C A U T I O N
Attempting to charge the device rated more than 2 amps could damage the USB charging port and/or the
mower. Always close the USB cover when not in use to prevent water and debris from becoming trapped
in port.
Right control panel ( with operator seated ) (See Figure 3.)
• Digital display:
This display shows important electrical system information. Refer to the
Electrical
section
for complete information.
• Master power ignition switch:
a two position switch: OFF and ON. With key inserted, rotate it
clockwise to the ON position; conterclockwise to OFF position.
• Drive speed control button:
Press the button to drive in high speed means thatthe maximum
drive speed will be 7 mph. . Press the button again to drive in low speed means that the maximum
drive speed will be 4 mph. Drive in low speed for inexperienced operators or when trimming around
objects, buildings and other obstacles.
NOTE: Get comfortable with mower before using “High Speed” setting. The maximum speed may be
adjusted at any time, whether the mower is in motion or not.
• Hi/Lo blades speed button:
Press the button to work in high speed mode. Press the button again to
go back to low speed mode. High blade mode is a higher blade speed for cutting thicker grass, while
low blade mode provides lower blade speed for lower battery consumption on thinner, drier grass
areas.
NOTE: Mowing time will be increased when mowing in low blade mode.
• Deck blades On and OFF switch:
This switch engages the deck motors. Pull the switch up to
engage and push switch down to disengage the motors.
• LED light button:
Press the LED light button to light up the work light.
NOTE: The light cannot serve as the drive light.
I M P O R T A N T
Never engage deck motors when the deck is under load. Motors or deck could be damaged.
USB port
Storage area
Fig.2
