4. Connect all cables as required - see “Rear connections” below.
Rear connections
Remarks: The photo above will differ for different models
The rear connectors are:
1.
FUSE
2.
Power Input
3.
DVI-1 Input
4.
DVI-2 Input (N/A for AWM-1200 and AWM-1500)
5.
VGA-1 Input
6.
VGA-2 Input (N/A for AWM-1200 and AWM-1500)
7.
CVBS-1 Input (Composite Video) for AV input
8.
CVBS-2 Input (Composite Video) for AV input
9.
CVBS-3 Input (Composite Video) for AV input
10.
RS232 Input
Planning the installation
Before you install your display, the following points should be considered:
• Power requirements.
• Display location and mounting options.
• Additional accessories, e.g. keyboard or speakers.
Power requirements
Your Sunlight Viewable display is designed to run on boat’s DC power systems rated at 12 V
or 24 V. Your AWM Series Display is equipped for a 9~36V DC wide range of power input.
The DC power system should be either:
• Negative grounded, with the negative battery terminal connected to the boat’s
ground,
• Floating, with neither battery terminal connected to the boat’s ground.
Grounding the display
It is important that an effective radio frequency (RF) ground is connected to the display.
You can ground the display by connecting the ground wire (gray) of the power input
cable to the grounding screw on the back of the monitor located near the power connector
1
2
3
4
5
6
7
8
9
10
the nearest ground point of the boat's RF ground system on the other end.
on the monitor end, and
11
