Green Energy ANTEK AIR MAGNA 100, Руководство по установке и обслуживанию

Страница: 27 / 34

AIR MAGNA 100
GREEN ENERGY SYSTEMS
27
7.Maintenance and trouble shooting
7-2 Malfunctions and treatment
Warning
If any fault occurs and the unit stops running, please contact your dealer or after-sales
technician to solve the problem. Please do not dismantle the unit and do repair by your
own in order to avoid any unnecessary injury.
When the unit has abnormal fault, please immediately cut off the power supply, do not
force it to run, otherwise there will be more damage.
7-3 Cleaning
Warning
For the sake of safety, the unit much be turned off and the power supply is cut off before
the cleaning.
Please take care to not damage the temp sensors during the cleaning.
1) Please be careful of those sharp metal edges and evaporator fins during the clearing to
avoid the injury caused by improper operation.
2) Regularly check the air inlet and air out and see if there is any blockage.
7-4 Maintenance
Attention
When the unit is prepared to be put in use again after a period of leaving unused, please
check the air inlet and air outlet to see if there is any blockage. If there is blockage, please
clean up immediately.
1)Before the use of the unit in each season, Please clean the filter on the water circuit
system to make sure the smooth water flow
2)During the unit operation, when the water flow is mall and the water temp difference is
too big, please check if the filter of the water circuit is clear.
3)Before the use of the unit in each season, please check if the heat exchanger surface is
clean. If there is too much dirt or impurities, please contact your dealer or the after-sales
serviceman to do the cleaning in order to make sure the good heat exchanging efficiency
and using effect.
4)If there is plenty of snow in winter, please block up the unit before install it to avoid the
blockage of the air outlet because of the deep snow.
7-5 After-sales service
When the unit can’t work normally, please immediately turn off the unit and cut off the
power supply, then contact the local dealer or professional technician to solve the problem.