❏
3. Remove the covering from the two tail-skid mounting
holes on the bottom of the fuse. Enlarge the tail-skid
mounting holes with a 1/8" [3mm] drill. Glue the nylon tail-
skid in place with medium CA.
Note: An alternate servo setup can be used if your radio
does not offer V-tail mixing and you want to have an active
rudder. See
“Optional Rudder Modifications,” on page 16.
❏
1. Trim the servo tray to fit your servos.
❏
2. Glue the V-tail servo supports to the servo tray. The
side you glued the supports onto is now the bottom. Note: If
you used servos smaller than standard, fill the cut lines with
medium CA.
❏
3. Fit the tail servos into the servo tray. Drill 1/16" [1.6mm]
holes for the servo screws and apply thin CA to the holes.
Mount the servos to the tray with the screws provided with
the radio gear.
❏
4. Glue the hook and loop material to the bottom of the
servo tray.
Install the Radio
13