GREAT PLANES Ultra Sport 40 Plus, Инструкция по эксплуатации

Страница: 31 / 62

mark with CA. Also, glue F5-A in place. Both formers should
be 90 degrees with the top of the fuselage.
❏
36. Use the die-cut 1/16" [1.6mm] balsa aft template
(AT) to glue the die-cut 3/32" [2.4mm] balsa former F4-A at
the required angle with CA.
❏
37. Locate the two 3/16" x 3/16" x 36" [4.8mm x 4.8mm x
914mm] balsa sticks and glue them in place with CA. Check
the fuselage plan and formers section view for the exact
position of these.
❏
38. Locate the two die-cut 1/16" [1.6mm] balsa cockpit
floor (CF) pieces and glue them together as shown. Note
that one end of each of the die-cut pieces is wider than the
other end. The wider ends must be on the same end.
❏
39. Insert the cockpit floor in the space between F3-A
and F4-A. The wider end of the cockpit floor must be
towards the front of the fuselage. Because of the angle of
the canopy formers, you may have to slightly sand the
cockpit floor and/or formers F3-A and F4-A to get a good fit.
Also, there will be a gap between the center of the cockpit
floor and the canopy formers F3-A and F4-A. This gap will
be later filled with filler. Once you are satisfied with the fit,
glue CF in place with CA.
❏
40. Locate the 1/8" x 1/4" x 30" [3.2mm x 6.4mm x
750mm] hardwood spar. Cut it to fit and then glue in the top
notches in the top of the aft (turtle deck) and forward (front
deck) formers as shown above. Use CA to glue it in place.
31