GREAT PLANES Ultra Sport 40 Plus, Инструкция по эксплуатации

Страница: 14 / 62

❏ ❏
7. Locate two 1/8" x 1/4" x 30" [3.2mm x 6.4mm x
760mm] hardwood wing spars. Insert them in place in the
ribs as shown. You should now have the top and bottom
wing spars inserted on the wing ribs as shown. Do not glue
the spars in place yet.
❏ ❏
8. Locate the die-cut 1/8" [3.2mm] wing trailing edge
(TE). Insert it into the notches at the trailing edge of each of
the ribs. Be sure that the tall end of TE is at the root of the
wing. Line up the ribs and webs with the plans. Place
weights on top of the structure to make sure it sits flat
against the building surface. Use thin CA to glue all the parts
together.
❏ ❏
9. Locate the die-cut 3/32" [2.4mm] wing rib W1.
Place the rib in the notches in MSW at the root of the wing.
Use the die-cut dihedral gauge (DG) to set the correct
amount of dihedral for the root rib W1. Insert the trailing
edge notch on the rib in its slot in TE. Glue W1 in place with
medium CA.
❏ ❏
10. Locate the die-cut 3/32" [2.4mm] dowel plate
doubler (DP). Insert it as shown in the slot in W2 and the
leading edge of W1. Make sure it is inserted at 90 degrees
from the building surface. Glue it in place with medium CA.
❏ ❏
11. Carefully cut the portion of the rib W2 that is
between the wing spars. This is done to allow the wing joiner
to later be inserted between the wing spars.
❏ ❏
12. Locate the die-cut 1/16" [1.6mm] aft shear web (ASW).
Insert it between ribs W1, W2 and W3, twist it and push it
against the wing spars. Glue ASW in place with thin CA.
14