12
❏
7. Same as was done with the stab, connect the rudder
pushrod to the
middle
hole in the rudder horn and install the
90-degree pushrod connector. Fit the rudder pushrod and
fi n into position holding the fuselage by the bottom under
the stab and holding the fi n at its base as shown. Carefully
work the fi n into position until it is almost, but not quite, all
the way in.
❏
8. Fit the tail gear wire into the tube in the bottom of the
rudder, then install the fi n the rest of the way into the fuselage
until it is snug and secure.
Note:
The fi n is held into position
with built-in magnets (which also lock in the stab), so no glue
is required.
This is what the rudder/pushrod/tail wheel assembly looks
like when properly installed.
❏
9. View the bottom of the FlyLite looking at the alignment
between the rudder and the tail wheel—the two should be
centered (or very nearly centered) with each other so the
plane will roll straight. If necessary, use the included hex key
wrench to loosen the set screw in the collar. Center the tail
wheel with the rudder, and then tighten the screw. Use care
to tighten the screw
just enough
to lock the tail wire into
place. Otherwise, you may strip out the plastic.
