26
M_LS900 Fibre - LS900 Edge_EN_C
Recommendations for installation
Head mode (option: suction hose)
Before selecting head mode, install the suction hose on the machine. Install the hose only for engraving work at
slow speeds of movement (maximum: 1 m/s). At high speeds, it could be pulled off and damage the machine.
Suction hose: installation
1. Remove the protective cap on top of the head. Gently install the hose in place of the cap.
Do not press too hard on the head, otherwise it could be displaced or damaged.
1.
Protection cap(s)
2.
Suction hose (optional)
3.
Tube
4.
Mounting point
2. Install the suction hose on the tube at the bottom of the engraving area. Attach the spring to the
mounting point.
Always remove the suction hose before switching to general or high-speed head
movement mode.
Air extraction system - Minimum characteristics:
Head mode
General mode
Air flow rate
>150 m
3
/h
>300 m
3
/h
Under vacuum (maximum)
>20 kPa
>0.5 kPa
Hose diameter
100 mm (3.937 in)
100 mm (3.937 in)
1
3
4
2
3
2
