23
M_LS900 Fibre - LS900 Edge_EN_C
I. Recommendations for installation
The physical installation and connections must be done by a Gravotech approved technician. Turn off
the machine before any intervention (put the On/Off switch in the "O" (Off) position).
1.
Physical installation
•
Place the machine on a horizontal, stable and clean surface that can support 170 kg (374.786 lb) or more.
•
Check that the engraving table is level in both directions (adjust with a spirit level).
•
Place the machine in a clean, ventilated environment. Choose the location that offers the shortest and
most direct route to the air extraction system (see: Air extraction system (option)
.
•
Avoid small, confined, unventilated spaces. Some materials continue to emit gases for a few minutes
after laser marking or cutting. The presence of these materials in a confined, unventilated room could
contaminate the room.
To provide good ventilation and prevent the laser source, power supply and/or control
unit module from overheating, leave a clear space of 20 cm (7.874 in) all around the
machine. The back of the machine should be kept clear and should not be close to any
items of furniture. It must not be placed on a shelf or installed in a corner.
Overheating could seriously damage the machine and lead to major costs.
On / Off switch
