44
M_LS900 Fibre - LS900 Edge_EN_C
Using the machine
7.
Start-up marking
1. Switch on the air extraction system.
2. Select one of the 2 modes (see: Air extraction system (option).
3.
Check that the object is correctly positioned in the engraving area.
4. Check the focus.
5. Check that the door is closed.
6.
Check that the screen is displaying the file name.
7. Press the key:
(control panel).
8.
Removing and reloading material
The laser beam is shut off once the machine has finished processing the material. The head goes back to the
origin (top left corner).
Before opening the door, wait a few seconds for any remaining fumes emitted during the marking or cutting
process to be removed by the extraction system. In the L-Solution driver, it is possible to enter a timeout value
to set a delay before the air extraction system stops when marking is finished.
Open the front door. Remove the material.
Load the next material. If it is the same material as the one before and the same file is being executed, close
the door. Start-up marking: Press the key:
.
