GRAUPNER X-4S HoTT SJ, Руководство по эксплуатации

Страница: 11 / 16

12
<Steering wheel operation>
◎ LED and Buzzer indication
◎ Receiver Port Description
LED & Buzzer Status
Descriptions
RX BIND ON
RX BIND OFF
Fail Safe Setup/Cancel
Free
Warning Status
Tx Receive Rate Low
Sensor Warning
Rx Ex Temp High
Rx Ex Volt Low
Rx Voltage Low
Tx Low Battery
Range TEST
Bind Switch
Push
-
Push
(Bind on status)
Push 3sec
(Bind on status)
-
-
-
-
-
-
RED
-
-
GREEN
ON
Slow flash
Buzzer
-
-
1cycle
2cycle
3cycle
4cycle
5cycle
6cycle
1cycle
2cycle
3cycle
4cycle
5cycle
6cycle
-
-
-
-
-
-
-
Slow flash Low 2Time(90sec)
-
-
Low 3Time
Low 2Time
Port1
Port2
Port3
Port4
Function
Ch1 Signal output
Ch2 Signal output
Telemetry Sensor / Batt
Temp Sensor/ Voltage Sensor
(HoTT-v1 Sensor only)
Neutral Neutral Full Forward Full reverse(brake)
T/V CONNECTOR
B/T CONNECTOR
CH2 CONNECTOR
CH1 CONNECTOR
1) Port 1, 2 should be connected with the servo or ESC.
2) Port 3 supports low voltage warning alarm with beep and LED
indicator.
In addition, it is available to use with telemetry sensor.
When using receiver battery (Nixx 4~5 cell, LiPo 2 cell), it needs to
be connected to Port3.
As for low voltage warning alarm, the default value is 3.7V.