GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors 11/2010
13
Glue the two horns in the rudder as shown in the following picture, and connect the
pull-cables to the plastic horn lugs. Please take particular care over crimping the
cables, to avoid any possibility of the rudder linkage coming adrift in flight.
The rudder servo should be installed in the servo plate at the front of the fuselage.
Connect the pull-cables to the double-ended servo output lever using threaded
couplers, nuts and clevises, as shown in the photo. Adjust the system so that the
rudder is exactly at centre when the servo is at neutral.
Fix the fairing support block to the noseleg using an M4 socket-head cap screw and
nut, as shown in the picture. Loosen the grubscrew in the end face of the spring strut,
slip the wheel axle through the cross-hole, and tighten the grubscrew firmly to clamp
the axle.
