GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors 11/2010
10
Drill pilot-holes in the wings to suit the retaining screws, then screw the clamps and
the wheel fairing support block to the wing.
You will need to file away the inside of the two fairings to provide clearance for the
wire undercarriage units. Note that the convex side of the wheel fairings must face
outwards. Loosen the grubscrew in the end face of each spring strut, slip the wheel
axle through the cross-hole, and tighten the grubscrew firmly to clamp the axle. The
wheels can now be attached to the axles using collets and grubscrews. Apply UHU
thread-lock fluid to the grubscrews to prevent them working loose.
The wheels and wheel fairings must be aligned exactly parallel with the fuselage
centreline.
The final stage on the wing is to install the landing searchlight.
Fit the two LEDs in the white plastic holder as shown in the following photographs,
and secure them with a little UHU Kraftkleber.
