GRAUPNER/SJ GmbH D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors.
02/2014
4
Fit the propeller on the motor shaft as shown in the picture: the clamping screw must
engage on the machined flat in the shaft. Tighten the clamping screw firmly using the
allen key. This completes work on the fuselage.
The next step is to glue the four plywood parts in place as shown. It is essen-
tial to sand the joint surface of all four rectangles to obtain really strong glued
joints. Glue the rectangular plywood plates to one wing panel to act as guides. The
wing panels can now be glued together: apply glue to the whole of the contact area.
Do not use activator, otherwise you may not have enough time to align the two wing
panels relative to each other before the glue sets.
