GRAUPNER Falcon 12 plus, Руководство пользователя

Страница: 26 / 34

26 / 34
S1038_Q06_V1.0pn_en
VIBRATION FILTER, VIBRATION FILTER2
MULTICOPTER BASE
ESC DSHOT
MODE NORMAL
MINPOWER % 5
T YPE QUADRO XI
VIBRATIONS FILTER 50
FREEST YLE 1
VIBRATIONS FILT.2 70
If you hear , for example, "clicking" noises in the motors by widely
fluctuating speeds or vibrations during the flight, such as in low
throttle or under hover conditions, these vibrations can be filtered
out with the options "damping" and "vibration filter". Preferably,
start with the "vibration filter":
Configure vibration filter step-by-step
1. In the transmitter assign a rotary or slider to a free control chan-
nel, e.g. channel 12
2. Select this channel in the value field of the "VIBRATION FILTER"
line.
3. In flight, adjust the "VIBRATION FILTER" with the selected control-
ler until the motor noises disappear or at least cannot be further
reduced and the rotor speeds are as constant as possible.
4. Leave the control in this position.
5. After landing, read out the set value found in the "VIBRATION FIL-
TER" line of the telemetry menu and then set it manually in the
value field, see "67" in the two examples on the left.
6. If vibrations still occur during the flight at a different speed, the
filter may need to be adjusted slightly or even adjusted according
to gas.
Adjustment range: 100 … 1, MIN, (0)C5, (50)C6 … (50)C16
The usual adjustment range of the vibration filter is between "65"
with 4 ... 5 inch rotors and 80 with 3 inch rotors.
Extremely low values should be avoided as these will worsen the
flight behaviour.
Note
If a channel is selected in this line, but no control is assigned in the
transmitter or otherwise it influences its neutral position, the value
"50" in parenthesis is predefined.
COMPASS CALIBR
Note
This menu item is only visible after connecting the optional GPS
module, No. 33602.
After each change of the airfield the compass has to be recalibrated.
In contrast, the current calibration described below does not have
to be repeated every time.
Notes
• When using an HD camera, it must be turned on when calibrat-
ing the compass. Otherwise, the autopilot mode and the come
back home function only work when the HD camera is switched
off!
MULTICOPTER BASE
ESC DSHOT
MODE NORMAL
MINPOWER % 5
T YPE QUADRO XI
VIBRATIONS FILTER 50
FREEST YLE 1
VIBRATIONS FILT.2 70
MULTICOPTER BASE
ESC DSHOT
MODE NORMAL
MINPOWER % 5
T YPE QUADRO XI
VIBRATIONS FIL(67) C12
FREEST YLE 1
VIBRATIONS FILT.2 70