GRAUPNER Falcon 12 plus, Руководство пользователя

Страница: 12 / 34

12 / 34
S1038_Q06_V1.0pn_en
Fail-Safe settings
We recommend to set Channel 1 and Channel 5 to "Pos" according
to the transmitter instructions and to put the pitch control stick in
the motor OFF position before storing the fail-safe settings and to
set the attitude / rate mode switch to the "Attitude mode" position
so that the attitude mode is active in fail-safe situations and the
motors stop. If the optional GPS module, No. 33602, is connected to
the S1038 AIO FC , it is then recommended to set C1 on "halten" and
C5 and C6 on "Pos". So that, in the Come back home position, the
copter will fly back to the starting position if there is a loss of signal.
Note
As soon as a correct transmitter signal is detected by the receiver
module, this state is terminated and the pilot must take control
again.
Throttle Cut
For safety reasons, a motor stop switch must always be programmed
on the transmitter side according to the transmitter instructions.
Only when this is placed into the appropriate position, an undesired
start of the motors is reliably prevented.
But in order to be able to switch off the motors also in the Acro 3D
mode, another mixer has to be programmed. Namely, if the copter
is operated in the acro 3D mode with the rate mode enabled, the
motor stop function would not shut off the motors, but set them to
"full power backwards". To prevent this, the mixer must be pro-
grammed in such a way that switching the motor stop switch to the
motor OFF position also switches to the attitude mode, in which the
stop of all motors is ensured.
Programming step-by-step
1. Program a linear mixer of "S => 5" according to the transmitter
instructions.
2. Assign to this mixer the same switch with the same switching
direction, which switches to the attitude mode.
3. Change to the setting page of the mixer.
4. Set the "travel" symmetrically to +100%.
5. Change to the line "Offset".
6. Now either set the offset value manually to +100% or set the
motor stop switch to "motor ON" and then push the ENT key. In
both cases, however, the adjacent picture must arise.
FAIL SAFE
Pos
Hold
1 2
3 4 5 6 7 8
Delay 0.25s STO
raised min
timer
+6%
4:00
cut off
Race timer
–100% +150% 1
yes
1
=
fro
M1
M2
M3
S 5
?? ??
M4
M5
?? ??
?? ??
?? ??
1
=
to
L.MIX1
trv +100%+100%
offs
SEL STO
S 5
+100%