GRAUPNER Falcon 12 plus, Руководство пользователя

Страница: 23 / 34

23 / 34
S1038_Q06_V1.0pn_en
MODE
CONTROLLER SETTING (Not necessary with DSHOT)
To initialize the controller, the signal of the motor / pitch control stick
of the transmitter is transmitted directly to the speed controller of
the copter.
Setting the speed controllers step-by-step
1. Remove rotors for safety reasons
2. Make sure that the transmitter-side pitch signal reaches
± 100%.
3. In the telemetry menu of the transmitter, change the value field
of the "MODE" line to "CONTROLLER SETTING" and confirm with
ENTER.
4. Switch off the copter or unplug the battery plug.
5. Switch off the motor stop function of the transmitter.
6. Move the pitch control stick of the transmitter to the full throttle
position.
7. Switch on the copter or connect the battery.
8. Wait for the confirmation melody or, if no sound is heard, alter-
natively switch on the motor stop function after approx. 15 sec-
onds.
9. After approx. 15 additional seconds, check the function.
10. In the telemetry menu of the transmitter, reset the value field of
the "MODE" line to the original setting and confirm with ENTER.
11. Switch off the copter or unplug the battery plug.
12. If the motors do not start after completion of this process despite
active binding, the copter must be bound again.
NORMAL
This setting must be used for copters with speed controller without
reverse of the direction of rotation.
ACRO 3D
This setting is reserved for copters whose speed controllers are
equipped with direction reverse.
Note
For safety reason the " Type " and " Mode " changes take effect after
switching off and on the copter.
!
CAUTION
Since the power control operates differently in the rate mode, see
figure on the left, the motors may start rotating more or less when
switching from the attitude mode to the rate mode, depending on
the current position of the pitch stick. Therefore always mount the
Full thr. positive
Full thr. negative
Min. thr.
linear up to max.
Min. thr.
Throttle travel
Rate mode
Throttle travel
Attitude mode
linear
linear
Motor-off 75%