GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors. Id.-Nr. 0062273 3/2011
-
5
-
Connect the power system - but without fitting the propeller - and check that it
functions properly, referring to the instructions supplied with the power set.
Fit the countersunk plastic screw (22) in the threaded insert (11), then glue the insert
in the top of the fin as shown, again using cyano. Remove the plastic screw. The
fuselage shells (1) and (2) are now ready for joining. To be on the safe side, repeat
the check of the servos and the motor (without propeller), and temporarily fit the
pushrods (16) and (18) in the outer sleeves to ensure that they slide smoothly.
The photo below shows the fuselage shells (1) and (2) ready for joining.
The first step in joining the shells is to offer them up “dry” (no glue). It is a good idea
to secure the loose cables temporarily with tape to avoid them getting caught in the
joint.
