GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors. Id.-Nr. 0062273 3/2011
-
3
-
Fuselage and fin
You will find a strip of foam linking the bottom edge of the rudder to the fuselage; cut
this away, and move the rudder repeatedly from side to side to free up the integral
hinge line.
Glue the fuselage stiffening tube (3) in the right-hand fuselage side (1), followed by
the two “snake” outer sleeves (4), noting that the sleeve for the rudder should be
fitted first; it must project by 15 mm at the front end.
Caution: do not cut off the excess length of the snake sleeves (4) at the tail end, as
this might allow excess cyano to run inside them.
The illustration shows the small ABS parts included in the kit.
Do not remove these components from the sprue until you actually need them.
Unscrew the original output levers from the C231 servos, and set the servos to centre
(neutral) from the transmitter. Mount parts (5) to (9) on the servo output arms (6) as
