GrassFlap Cable Installation
WARNING: PROPER CABLE INSTALLATION AND MAINTENANCE
IS CRITICAL TO LIFE OF CABLE
4) AREAS TO PAY PARTICULAR ATTENTION TO ARE:
1. Do not bend cable wire.
2. Make certain the cable is not in a bind when the deck is raised either manually
or when mowing.
3. Leave enough slack where the cable is tied to mower to keep out of the belts
for the deck to raise and lower without straining the cable.
4. Avoid direct heat on cable, do not route near muffler
5. Maintain recommended bend radius of 6 inches for all bends.
3) MAINTAINING THE CABLE:
1. Be sure the rubber boot is in place to keep dirt and water out of cable.
2) PROPER PEDAL HEIGHT:
1. Adjust pedal height so pedal bottoms out with full pressure to
prevent cable from carrying full weight of operator. Start with
cable fitting as shown - adjust pedal end to raise pedal, adjust
flap end to lower pedal. Verify pedal height with flap in
balance (half open) position.
DO NOT BEND
1) Improper cable routing WILL cause failure, usually within
the first month of use. The first 1/2 inch of cable conduit
(black flexible part) must be straight in line with the end fitting.
Cable wire near ball must not be bent during installation.
Reference 6”radius
for ca
ble r
out
ing
.
5) MINIMUM BEND RADIUS
GrassFlap.com
Phone:
(502)594-3546 7
How to set
pedal height:
Pedal End
(1 thread showing)
Flap End
(1 thread showing)
this side
this side
