GRASS VALLEY KayakDD-1, Планирование и руководство по установке

Страница: 41 / 90

KayakDD-1 Digital Production Switcher
6.3.2 Table Top Mounting
In many cases the panel can just be put on a table. Gummed feet prevent accidental
movement of the panel.
6.3.3 Cut Out Dimensions for Surface Mounting
For surface mounting of the control panel the cutout dimensions are:
400 mm x 430 mm
CAUTION!
Regardless of mounting method or cutout dimensions, ensure that there is at least
2 inch (50 mm) of clear space at the rear of the panel below the mounting surface for
proper cable clearance and air flow.
6.3.4 Mounting Holes for Panel Fastening
For fastening the panel in a table there are four M4 thread drillings on the panel. Those
allow to fasten the panel from below the table. The length of the screws is dependent
on the respective thickness of the tabletop (see Figure 9 and 10 with mounting details
below).
The figure below shows the position of the mounting holes.
Four thread drillings
for panel fastening
Figure 10 Bottom View, Position of the Mounting Points
40 Planning and Installation Manual