
29: Status of valve for rain water filter
FV+
: Filter valve open
30: Status of house water system (Pump)
FV-
: Filter valve closed
31:
Visual representation of fill level
P+
: House water pump
running
32: Fill level %
P-
: No water being
with drawn
F
igure 7: Display in operation
6. Set up of the system control:
After putting into operation, the system control must be adjusted and programmed
according to the conditions and requirements of the individual users system. The
required settings are easily programmed. There are four buttons for this purpose.
All necessary programming data entries follow a menu displayed by the LCD. For
the set up follow all the points listed in table 1 in the sequence as shown. Should
any error in the sequence occur then it is necessary to begin the set up again from
the beginning starting with the tank height. Begin the programming of the settings
by pressing the button marked “MENU”.
With the buttons “+” or “-” the menu may be scrolled backwards and forwards.
With the respective menu point shown the values may be altered. For this the
button “ENTER” must be used. The “?” displayed in the LCD will now change to a
“>”graphic character. With the “+” or “-” the desired value may now be entered
according to individual requirements. When the desired value has been entered this
must be confirmed by pressing the “ENTER” button. The value is only then taken
over and stored in the programming of the unit.
Page 15
Содержание SILENTIO
Страница 27: ...Room for your notes Page 27 ...