Graco TexSpray Compact HP, Инструкция-перечень запасных частей

Страница: 9 / 28

9 308718
Preparation
Wetting the Hose Before Pumping Texture
Material
Wet the inside of the hose before each use to flush out
sediment and to prevent the texture material from
packing out the hose.
1. The hopper (J) capacity is 12 gallons (45 liters).
Pour a gallon (3.8 liters) of clean water into the
hopper. See Fig. 12 on page 10.
2. Close the gun air valve (423); the system primes
easier if no air is supplied to the gun. See Fig. 11.
3. Turn the ON/OFF switch (D) ON. Aim the gun into
the hopper (J), and trigger the gun to circulate the
water for a few minutes and to wet the inside of
the fluid hose. See Fig. 12.
4. Trigger the gun into a pail to lower the water to the
hopper strainer (L) level. See Fig. 12.
5. Turn the ON/OFF switch (D) OFF.
6. Open the gun air valve (423) to relieve the
compressor air. See Fig. 11.
Fig. 11
closed
423
open
7136A
Mixing the Material
CAUTION
This system is designed for use with only certain
types of material. Any other use could seriously
damage the unit.
Do not use any solvent-based materials. Use
only water-based materials.
Use only simulated acoustic and gypsum-based
wall texture materials in this system.
Do not spray cementious materials, which will
damage the pump.
Proper material mixture is essential. The pump will
not operate if the material is too thick.
NOTE: Mix the material in a separate container and
pour it into the hopper for best results.
Slowly add one bag of texture material to clean water
as instructed on the bag instructions. Agitate to a
smooth, lump-free consistency. Thin the material as
needed before pouring it into the hopper. Material
must be mixed thoroughly to a consistency that
immediately folds back in as you draw your finger
through the surface of the material. For the best
results, do not use partial bags of material.