Graco TexSpray Compact HP, Инструкция-перечень запасных частей

Страница: 13 / 28

13 308718
Spray Techniques
To Get Less Material
Try any one or a combination of these methods:
Screw in the gun fluid regulator knob (418).
Use a smaller tip.
Reduce pump pressure. Use the regulator.
To Get More Material
Try any one or a combination of these methods:
Turn the air flow valve (424) to decrease (–).
Unscrew the fluid knob (418) to increase trigger
travel.
Note: Maximum trigger travel occurs when trigger
bail (401) can hold trigger in open position. Fig. 13.
Use a shorter hose.
Use a thinner material mixture.
Try a larger-orifice tip.
Increase pump pressure (use the regulator).
CAUTION
Turning the knob (418) out too far will remove the
knob and the gun will not shut off when the trigger is
released.
7134A
OUT
423
Fig. 13
418
IN
424
401
Preventing Material Surge
To prevent material surge at the beginning of a spray
pattern, slowly squeeze the trigger to the fully triggered
position while moving the gun quickly.
For Continuous Spraying
Use the trigger bail (401) to hold the trigger open to
reduce operator fatigue.
Check Material Consistency Periodically
Check and thin the material as needed to maintain the
proper consistency. The material may thicken as it sits
and slow down production or affect the spray pattern.
IN
OUT
7133A
423
Fig. 14
418
424
401